Quantcast Ford Truck Club Forum - View Single Post - Oil pan question
View Single Post
  #9  
Old March 5th, 2015, 06:28 PM
chesster51's Avatar
chesster51 chesster51 is offline
 

Join Date: Jan 2015
Location: Middleburg, FL
Posts: 40
Likes : 0
Liked 0 Times in 0 Posts
Default

Quote:
Originally Posted by JSoko View Post
what will the block of wood be pushing against ?

also check your engine mounts while you got it up, as well as the one for the trans on that crossmember
they'er not that expensive, and would be easy to replace while you got it up
Just replaced all three mounts about two weeks ago. I plan on using a piece of 2 x 4 long enough to span the width of the oil pan and raise it there. The main pressure will be on the vertical sides of the oil pan. Did it this way to replace the motor mounts with no issue. I'm hoping to raise it and shim it up with wood under the mounts so the jack can be removed.