Quantcast Ford Truck Club Forum - View Single Post - drive shaft center support (carrier Bearing)
View Single Post
  #11  
Old March 26th, 2010, 09:14 AM
catmechanic07's Avatar
catmechanic07 catmechanic07 is offline
 

Join Date: Jun 2009
Location: Virginia
Posts: 2,307
Likes : 61
Liked 14 Times in 14 Posts
Default

Next time.........Air chisel and a torch. Heat the sleeve and chisel like hell! Done it 100's of times. I dont care for the cutting tool method because (1)..its hard to get in the area you want for an even cut, and (2) you never know exactly how deep your cutting and you dont want to damage the flange for the new one to go on.

Ive never had vibration after installing a new one unless it wasnt on correctly. Maybe it isnt on all the way or its jammed on wrong. Did you mark your drivline so the splines line back up in the exact same slots? One tooth off with cause BAD vibration

Lowriders are for guys who can't get it up!
Sissy's drive 2wd's! (you know who you are!!)




Black Sheep of FTC