Quantcast Ford Truck Club Forum - View Single Post - 1969 f100 240 ignition issues
View Single Post
  #1  
Old May 14th, 2019, 10:13 PM
green machine's Avatar
green machine green machine is offline
 

Join Date: May 2019
Posts: 1
Likes : 0
Liked 0 Times in 0 Posts
Default 1969 f100 240 ignition issues

Recently bought this truck a old Montana forest service truck.It ran when I got it, but not very well. I put a new carb on it and it was running pretty good. I drove it 20 miles, shut it down for 5 minutes and it would not restart. After a 65 dollar tow bill got it home. I did not have any spark. It had point conversion dynalife solid state kit so I took that out and put the old points back in that were in the glove box. I did get the truck to start, but it is only firing on cylinder 1 and 5. New plugs and coil. Power at coil is 6-7 volts. New battery. Not sure what is going on. Do I have a low voltage issue, bad plug wires and bad distributor? There is not that much to it, but haven't figured it out yet.
Thanks,