Quantcast Best way to replace fuel pump 94 Ranger - Ford Truck Club Forum








New Posts






FTC Toolbar

Social Sites

Log Out

Ford Truck Club Forum > RANGER | MAZDA-B > 1993-1997 Ford Ranger

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools Display Modes
Old September 11th, 2012, 02:42 PM
jelarf's Avatar
jelarf jelarf is offline

Join Date: Aug 2012
Location: Fort Mohave, AZ
Posts: 26
Likes : 0
Liked 0 Times in 0 Posts
Default Best way to replace fuel pump 94 Ranger

Just bought a 1994 Ranger, great price (350.00 120,000 miles) ran well started to sputter and pop sounds to me like fuel pump is going out or has gone out...so is it easier to pull tank from bottom or pull bed off?...this has been an AZ truck so bolts not rusted...
Old September 11th, 2012, 05:28 PM
JSoko's Avatar
JSoko JSoko is offline


Join Date: Jun 2009
Location: Northwest Georgia
Posts: 15,074
Images: 630
Likes : 36
Liked 188 Times in 170 Posts

not sure about the Ranger but at either 4 or 6 bolts and a friend to help lift
thats the route I'd take
also spend some time lineing it back up before you bolt it down
check thr gap at the cab then stand back and sight for straightness, then check the distance from the side of both rear tires, a string with a bolt or nut with act as aplumb bob if ya aint got one, slip a string over the bed on both side to get it right then recheck the cab.

the fuel pump replacement is the easy part

For Those Who Fought For It...
Freedom Has A Taste The Protected Will Never Know.

Old September 11th, 2012, 06:13 PM
Booba5185's Avatar
Booba5185 Booba5185 is offline

Join Date: Dec 2011
Location: Ava, MO
Posts: 2,711
Images: 747
Likes : 13
Liked 35 Times in 30 Posts

Yea I agree with J, my Full size bed wasn't so heavy, so I'd say a Ranger bed would ne even lighter. Much less frustrating that trying to lift and lower a gas tank with gas in it.

89 F-150 5.0l AOD 2x4, 3.55 LS(+4), Converted to HO Roller, 3g Alt, GT40Ps, Y-pipe, Rerouted PCV, Dual Taurus E-fans, Explorer Injectors, Remote ICM, DIY Cold air, Rubber Vacuum System, Tranny cooler, Remote Tranny filter, Saginaw P\S swap, F350 Brakes, more.

Old September 11th, 2012, 06:59 PM
catmechanic07's Avatar
catmechanic07 catmechanic07 is offline

Join Date: Jun 2009
Location: Virginia
Posts: 2,307
Images: 25
Likes : 61
Liked 14 Times in 14 Posts

Or you can take a cut off wheel and cut a hole in the bed large enough to pull the pump. Make a hinge or put it back permanent. I cut the floor out of a van at work instead of pulling the tank. The van is used for parts pick-up so no big deal. Choice is yours!

Lowriders are for guys who can't get it up!
Sissy's drive 2wd's! (you know who you are!!)

Black Sheep of FTC

Thread Tools
Display Modes

(View-All Members who have read this thread : 8
BigBlue79 , Booba5185 , catmechanic07 , DoubleDee , jelarf , JSoko , pwallace67 , scbill

Similar Threads
Thread Thread Starter Forum Replies Last Post
1995 F150 Dead Fuel Pump nine5flareside 1992-1996 Ford F150
43 June 10th, 2012 02:11 AM
Fuel Pump Relay Ridgerunner Garage Talk: Shop Class 101 6 March 26th, 2012 06:21 PM
How to Replace Ranger Brake Pads JSoko Garage Talk: Shop Class 101 0 November 1st, 2011 01:51 PM
How to Replace the Front Rotor on a Ford Ranger JSoko Garage Talk: Shop Class 101 0 November 1st, 2011 01:46 PM
How to Install an Oil Pump in a 2.3L Ford Ranger JSoko Garage Talk: Shop Class 101 0 September 19th, 2011 07:33 PM

fuel , pump , ranger , replace

Forum Jump

   Current Advertisers Privacy Policy FAQ Home Blog Archive Top

FordTruckClub.net is not authorized, endorsed or affiliated with the Ford Motor Company
or any of their subsidiaries. Ford® is a registered trademark of the Ford Motor Company

Powered by vBulletin® Version 3.8.6 Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.